A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.
Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
We're licensed and insured for residential and light commercial interior drainage work across Adrian, MI.
Interior drainage installs are scheduled locally, without routing through a national call center that adds weeks to the timeline.
Sump basin and pump costs are itemized separately so you can see exactly what makes up the total.
Every system is tested with a hose before we consider the install complete.
We scope every Interior Drainage System job in person before quoting it, since two properties with the same symptom rarely need the same fix.
We route the full perimeter or targeted sections depending on where moisture is actually entering, based on the inspection.
Basin placement is chosen for the shortest, most direct discharge path away from the foundation.
For finished basements where cutting the slab isn't practical, a baseboard channel system captures wall seepage without disturbing existing flooring.
The cove joint where wall meets floor is sealed and tied directly into the drain system so water is captured right at the entry point.
We camera-inspect old systems where accessible to determine whether repair or replacement makes more financial sense.
Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
We also check existing drainage, if any, to determine whether repair or new installation makes more sense.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
We test the system with water flow before finishing to confirm proper slope and basin performance.
"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Adrian Homeowner
"Finished basement meant we couldn't cut the slab easily. Baseboard channel system worked great as an alternative."
— Adrian Customer
"They tested the system with a hose before calling it done, which gave us confidence it would actually work in a real storm."
— Adrian Homeowner
"Clean install, patched concrete matched the existing floor color almost perfectly."
— Adrian Customer
Not always — if water is only entering along one wall, a targeted section can be enough, which we determine from inspection findings.
Drain tile requires cutting the slab; a baseboard channel is a lower-disruption alternative that captures wall seepage without floor demolition.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
Basin size is based on expected water inflow from the drain tile's linear footage and your Adrian, MI area's typical rainfall intensity.
Cutting the slab does involve some disruption, but we work in sections and clean up debris as we go.
We give you a realistic timeline in the written quote based on your specific basement layout.
We install and repair interior drainage systems throughout Adrian and the surrounding Adrian, MI service area, including the zip codes listed below.
Zip codes we serve in Adrian, MI: 49221
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
